Specification:
Enclosure | Front plate: Aluminum , IP65. Case: Aluminum | ||
Run Mode | 2-speed material transfer mode, Setpoint comparison，Over/under, Check weigh，Reduction weigh，Peak force measurement，Gross/net fill | ||
Signal Range | -20mV~+20mV | Increments | 1,2,5 x 10n (n=-3 ~1) |
Max. Sensitivity | 0.5uV/d | Max. Resolution | 1/50,000 |
FS Drift | 3ppm/°C | Linearity | 0.003%FS |
AD Refresh Rate | 100Hz | Cells Load | Four (4) 350 ohm load cells |
Display | 7-digit 0.4’ segment LED | ||
Keypad | 4 tactile-feel keys; polyester overlay | ||
Discrete I/O | 2xDI,3x Relay DO 2 Inputs; 3 Outputs(220VAC @ 5A) | ||
USART | COM1: RS232; COM2: RS485 | ||
Serial Protocol | MODBUS-RTU, Command output, Continuous Output | ||
Option | 4~20mA/0~10V， Profibus DP | ||
Power Supply | 18~30DCV, 60mA | ||
Operating Temperature | -10°C ~ +40°C，Relative humidity:10%~90%，non-condensing |
Where it is used
Batching and filling controllers weigh product to set targets and control valves, feeders or conveyors automatically, for consistent batches with less waste. Browse batch control panels or all weighing indicators.
Installation and calibration
After an indicator is fitted, the scale must be calibrated, and a trade scale verified and stamped. Our technicians install indicators and calibrate scales on site through our calibration and repair services. Request a quote.
Frequently asked questions
Usually, through its relay or setpoint outputs. Tell us what valves, feeders or motors you need to control.
Yes. We wire, configure and calibrate the system with your team.
Yes. We fit the indicator, calibrate the scale and support it across Kenya.
